Deep-sea Scientific Drilling Program to Study Volatile Earthquake Zone Launched
The Nankai Trough Seismogenic Zone Experiment (NanTroSEIZE) gets underway....
The Nankai Trough Seismogenic Zone Experiment (NanTroSEIZE) gets underway September 21, with the Japanese drilling vessel Chikyu departing from Shingu Port with scientists aboard, all ready to log, drill, sample, and install monitoring instrumentation in one of the most active earthquake zones on Earth. The vessel's launch starts the first of a series of scientific drilling expeditions that will retrieve geological samples and provide scientific data from the Nankai Trough fault zone for the first time. Situated off
1) the incoming sediment of
2) the frontal thrust system at the toe of the accretionary wedge (where sediment is added to tectonic plates through frictional contact),
3) the mid-wedge multiple-fault system (mega-splays), and
4) two, approximately 1,000-meter deep holes at sites identified for later deep penetration into seismogenic zone faults.
The current Stage 1 expedition will continue until November 16. The following Stage 1 expedition will sail from Nov. 17-Dec. 19, 2007, with new scientist participation.Logging While Drilling (LWD) investigations will occur at all Stage 1 drill sites. LWD operations consist of continuously drilling one or more holes at each site by drilling down at a controlled rate, with logging tools incorporated into the bottom-hole assembly, a relatively short distance (tens of meters) behind the drill bit. Log data are acquired very soon after the hole is cut, providing the best possible data quality. LWD operational and science data are crucial for optimizing subsequent Stage 1 expeditions and future drilling stages. The current NanTroSEIZE expedition is led by Co-Chief Scientist Harold Tobin, a marine geologist on the faculty of
.png)